Sub-Zero UC-15I Maintenance Manual page 2

Model UC-15I (Undercounter Ice Machine)
Cleaning and Sanitizing the Interior
An in place cleaning/sanitizing procedure should be
performed every six (6) months.
Damage to the ice machine caused by incorrect
chemical usage is not covered by the warranty.
Use only Sub-Zero approved ice machine cleaner
(part #7013400) and sanitizer (part #7013401).
In Place Cleaning / Sanitizing - This procedure
allows semi-annual in place cleaning and sanitizing of
the interior. The quality of the homes potable water
supply may call for more frequent cleaning intervals.
Use ice machine cleaner (#7013400) to remove lime
scale or other mineral deposits. Ice machine sanitizer
(#7013400) disinfects and removes algae and slime.
WEAR RUBBER GLOVES AND SAFETY GOGGLES
(AND/OR FACE SHIELD) WHEN HANDLING ICE
MACHINE CLEANER OR SANITIZER.
NOTE: Before beginning, removed all ice from the bin.
1. Prepare 4 oz (118 ml) of undiluted ice machine
cleaner (7013400 only) in a container that will fit
easily under lifted paddles
2. Press CLEAN button
machine will initiate a 2 minute harvest to remove
any remaining ice from the evaporator. When that
ice falls in the bin, remove it from the bin.
Figure 4-2. Start Clean Cycle, Press "CLEAN"
3. Wait 3 minutes until CLEAN light flashes
Figure 4-3), then add prepared cleaner by lifting the
water paddles and pouring directly into spray area
(See Figure 4-4). The ice machine automatically
times out a 10 minute cleaning cycle, followed by 8
rinse cycles, then stops. The CLEAN light switches
off to indicate the clean cycle is complete. This
entire cycle lasts about 30 minutes.
CLEAN light flashes 1 minute, then steady ON for 30 minutes
Figure 4-3. Clean Light Flashes = Add Cleaner
(See Figure 4-4).
(See Figure 4-2). The ice
(See
Figure 4-4. Pour Cleaner Into Spray Area
4. Prepare 1 tablespoon (15 ml) of undiluted ice
machine sanitizer (7013401 only) in a container that
will fit easily under lifted paddles
5. Press the CLEAN button again, this time to start the
sanitize cycle (See Figure
Figure 4-5. Start Sanitize Cycle, Press "CLEAN"
3. Wait 3 minutes until CLEAN light flashes
Figure 4-6), then add prepared sanitizer by lifting
water paddles and pouring directly into spray area
(See Figure 4-7). The ice machine automatically
times out a 10 minute sanitize cycle, followed by 8
rinse cycles, then stops. The CLEAN light switches
off to indicate the sanitize cycle is complete. This
entire cycle lasts about 30 minutes.
CLEAN light flashes 1 minute, then steady ON for 30 minutes
Figure 4-6. Clean Light Flashes = Add Sanitizer
Figure 4-7. Pour Cleaner Into Spray Area
NOTE: The ice machine will automatically continue
from previous operational state before clean was initiat-
ed. If the unit was in an ice making cycle, it will start
making ice again; if it was OFF, it will switch back OFF.
4-3
Maintenance/Cleaning/Adjust
(See Figure
4-5).
(See
#7012423 - Revision B - May, 2011
4-7).