Advertisement
TO AVOID SERIOUS PERSONAL INJURY AND PROPERTY DAMAGE:
· ALWAYS install equipment in a work area with adequate light and space.
· ONLY operate on a solid, level, nonskid surface that is nonflammable and away from sinks and water
hazards.
· NEVER bypass, alter or modify this equipment in any way from its original condition. Doing so may create
hazards and will void warranty.
GAS and GAS PRESSURE
Unit installation must conform with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, the National Gas
Installation Code, CSA-B149.1, or the Propane Installation Code, CSA-B149.2 as applicable and in
accordance with local codes.
The appliance and it's individual shutoff valve (to be supplied by user) must be disconnected from the gas
supply piping system during any pressure testing of that system at test pressures in excess of ½ psi (3.45
kPa).
These models are designed, built, and sold for commercial use only.
Instructions must be posted in a prominent location. All safety precautions must be taken in the event the user
smells gas. Safety information can be obtained from your local gas supplier.
UNPACKING
Unpack the hot plate immediately after receipt. Remove the gas hot plate from the crate; remove all packaging
on and surrounding the unit and be certain to remove all protective plastics and residues from all surfaces.
Make sure that all parts provided including the L.P. gas conversion kit are located.
If the machine is found to be damaged, save the packaging material and contact the carrier within fifteen (15)
days of delivery. Immediately contact CORE PRO or your local dealer of the equipment. You have no
recourse for damage after fifteen (15) days.
4
Advertisement
