Sharp MX-B376W Quick Start Manual page 21

LOAD PAPER INTO THE BYPASS TRAY
1
2
3
4
To add paper, press down the pressure plate until it locks, remove any paper remaining in the bypass tray, combine it
with the paper to be added, and place in the bypass tray again. If paper is added without removing the remaining paper,
a paper jam may result. A paper jam may also result if more than the specified number of sheets are added, or if the
paper stack exceeds the limit.
BEFORE USING THE MACHINE
Open the bypass tray and the
extension tray.
Push the center of the pressure plate
down until it locks into place.
Load the paper with the print side
facing down.
Insert the paper along the bypass tray guides all the way into
the bypass tray until it stops slowly. Inserting the paper with
excessive force may cause the leading edge to fold back.
Inserting the paper too loosely may cause skewed feeding
or misfeeds.
The paper must not exceed the maximum number of sheets
and must not be higher than the indicator line.
Set the bypass tray guides correctly to
the width of the paper.
Adjust the bypass tray guides so that they slightly contact
the loaded paper.
21