Subscribe to Our Youtube Channel
Related Manuals for Timotion TDH18P
Summary of Contents for Timotion TDH18P
- Page 1 Hand Control Programming-TDH18P 20211222 User Manual Hand Control Programming- TDH18P Version 5 December 2021 1 of 13...
-
Page 2: Table Of Contents
Hand Control Programming-TDH18P Contents Contents ..................................2 Disclaimer .................................. 3 1. User Interface Guide ............................. 4 2. Reset ..................................5 3. Adjusting the Height ............................. 6 4. Setting the Memorized Position ........................... 6 5. Setting the Upper and Lower Height Limit ......................7 6. -
Page 3: Disclaimer
Hand Control Programming-TDH18P Disclaimer This user manual is ONLY for generic TiMOTION products. Manufacturers may have altered product settings causing them to differ from this user manual. Please contact the manufacturer for a revised manual if the product settings are different than this manual. -
Page 4: User Interface Guide
Hand Control Programming-TDH18P 1. User Interface Guide Safety lock button Up and down buttons 3-digit height display Memory setting buttons USB charging ports* *USB charging ports: For charging electronic devices *OUTPUT 5V/1.2A only applies to 1000mm cable length. The actual charging efficiency will vary depending on final handset specifications and device(s). -
Page 5: Reset
Hand Control Programming-TDH18P 2. Reset Simultaneously press for 3 seconds. Continue pressing the buttons until both columns are in the lowest position. When finished with the reset, the control box will make a “beep” sound and the buttons can be released. -
Page 6: Adjusting The Height
Press button until the desk reaches the preferred height. 4. Setting the Memorized Position TDH18P supports a maximum of 2 memory positions. How to memorize a position: Adjust the desk to the desired height. Press the preferred memory button (1 or 2), with either for 2 seconds. -
Page 7: Setting The Upper And Lower Height Limit
Hand Control Programming-TDH18P 5. Setting the Upper and Lower Height Limit Setting the upper height limit: (1) Adjust the desk to the preferred upper height limit. (2) Press buttons together for less than 3 seconds, holding and release button. (Note 2) (3) Re-press for more than 3 times at a slow pace. -
Page 8: Presetting The Desk Starting Height
Hand Control Programming-TDH18P 6. Presetting the Desk Starting Height (1) Press button until the desk reaches its lowest position and then release button. Re-press button again for 5 seconds and the digital display will flash for 10 seconds. (2) Adjust the starting height number with the button. -
Page 9: Switching Metric And Imperial Unit
Hand Control Programming-TDH18P 8. Switching Metric and Imperial Unit (1) Press memory button 1, 2 and Lock buttons for 5 seconds. (2) The digital display will show “C-I”. If no further instruction is input within 5 seconds, the system reverts to normal operation mode. -
Page 10: Restore Factory Setting
Hand Control Programming-TDH18P 9. Restore Factory Setting (1) Refer to Chapter 2-Reset: after the “beep” sound, press buttons together for 15 seconds, the control box will twice make a “beep” sound. (2) The settings below will restore to the original factory settings: Memorized position ... -
Page 11: Power Saving Function - Waking Up The Control
This is an optional function for users who want to set up a sit or stand notification while changing posture with TDH18P. Press and hold memory buttons 2 and 3 for 3 seconds to enter the setting mode. The default value is no notification. - Page 12 Hand Control Programming-TDH18P 3-digit display Definitions No reminders (Default) Sitting for 10 minutes; standing, 50 minutes. Sitting for 20 minutes; standing, 40 minutes. Sitting for 30 minutes; standing, 30 minutes. Sitting for 40 minutes; standing, 20 minutes. Sitting for 50 minutes; standing, 10 minutes.
- Page 13 Hand Control Programming-TDH18P Change to sitting position: Buzzer: The buzzer will beep from fast to slow 5 times, notifying users to sit. Display: It will show up and down (see the image below) Note: Press any button to stop the display for reminders.
Need help?
Do you have a question about the TDH18P and is the answer not in the manual?
Questions and answers