IKEA SMAKOKA HBN 430/B Manual page 28

ENGLISH
- You can find specific local regulations
for some countries in the paragraph
"Reference to Local Regulations". If no
information concerning your Country is
given, please ask details to a qualified
technician.
- The connection of the hob to the gas pipe
network or gas cylinder must be made by
means of a rigid copper or steel pipe with
fittings complying with local regulations,
or by means of a continuous-surface
stainless steel hose complying with local
regulations. The maximum length of the
hose is 2 linear metres.
.
C
C
A
D
B
D
- Connect elbow (A) or (B) supplied with to
the hob inlet main pipe and interpose the
washer (C) supplied, in compliance with
EN 549.
- Washer (D) not supplied with the product.
IMPORTANT: if a stainless steel hose is
used, it must be installed so as not to touch
any mobile part of the furniture. It must
pass through an area where there are no
obstructions and where it is possible to
inspect it on all its length.
- After connection to the gas supply, check
for leaks with soapy water. Light up the
burners and turn the knobs from max
position to minimum position
check flame stability.
Electrical connection
WARNING
- This operation must be performed by a
qualified technician.
- The electrical connections must comply
with local regulations.
- The earthing of this appliance is
compulsory by law.
- Do not use an extension cord.
- IMPORTANT: the data relevant to the
voltage and power absorption are
indicated on the rating plate.
Assembly
After having cleaned the perimeter surface,
apply the supplied gasket to the hob.
Position the hob in the worktop opening
made respecting the dimensions indicated
in the Instruction.
28
to
L
Tierra (amarillo/
verde)
N