Preparing The Unit For Connection - Rheem Raypak Raymote Installation And Operation Manual

Preparing the Unit for Connection

1. Stand near the touchscreen of the unit. Press the
Wi-Fi icon on the touchscreen. See Figure 10.
Figure 10. Wi-Fi Connection
2. The Wi-Fi status screen should display the Wi-Fi
State, indicating "Config Mode" wireless connection,
and also the HOTSPOT identifier. See Figure 11.
Figure 11. Wi-Fi in Config Mode and HOTSPOT Identifier
NOTE: If the Wi-Fi State does not indicate "Config
Mode", press the "Reset" button on the touchscreen.
See Figure 11.
3. At this point your unit is ready for connection.
The following sections provide the instructions for Android
and iPhone devices.
4. In the Raymote app, press "+ Add a new device" for
the first device or press the menu button
at the top right corner of the screen, then press "+
Add a new device". See Figure 12.
NOTE: The first time you use a new phone, the Raymote
mobile app may require you grant permission to access
data. See Figure 13.
Figure 13. Grant Permission in iOS and Android
located
Figure 12. Add New Device
9