Synergy-Convenience-Receptacle - YORKVILLE Synergy SA102 Owner's Manual

Powered speaker

Hide thumbs Also See for Synergy SA102:

Service manual (38 pages)

Table Of Contents

Table of Contents

Yorkville Synergy Convenience Receptacle Installation (Cascade Installation)

RATED CURRENT

MAINS VOLTAGE

120V 60 Hz

(NORTH AMERICA)

230V 50 Hz

(EUROPE)

The LINE CURRENT LIMIT SWITCH allows the user to limit the maximum continuous current consumption to reduced

values as shown.

Tech Support: If you have any questions concerning your SYNERGY equipment don't hesitate to contact

ELECTRICAL SAFETY

It is always important to connect all sound reinforcement equipment to ac mains supply circuits that have proper electrical

safety grounds. Never break off the Earth Ground pin from a 3-prong plug. This pin provides personal protection from

electrical shock and protection of the equipment from lightning strikes and electrostatic buildup. It is also required for EMC

shielding. Replace the plug if the Earth Ground pin is missing.

1. Always connect the equipment to a circuit with a suitable electrical ground.

2. Do not overload the power cords and convenience outlets.

3. Always inspect the cords and plugs before use. Do not use outlets or cords that have exposed conductors, are worn or

damaged. Replace electrical cords that have worn or damaged insulation and remember to pull the plug not the cord to

prevent damage to the cord. Only replace with the equivalent heavy-duty cord supplied by the manufacturer.

4. The AC supply cord should be routed so that it is unlikely that it will be damaged. Protect the power cord from being

walked on or pinched. If the AC supply cord is damaged DO NOT OPERATE THE UNIT. To completely disconnect this

apparatus from the AC Mains, disconnect the power supply cord plug from the AC receptacle. The mains plug of the

power supply cord shall remain readily accessible. Unplug the apparatus during lightning storms or when unused for

long periods of time. Route cords away from traffic to avoid tripping hazards and unnecessary wear on the power cord.

5. Never Break Off the Third Prong on a Plug. Replace broken 3-prong plugs and make sure the third prong is properly grounded.

6. Keep line cords away from heat, water and oil. They can damage the insulation and create a shock hazard.

7. Do not tie cords in tight knots. Knots can cause short circuits and shocks. Loop the cords or use a twist lock plug.