Table of Contents
Advertisement
10
www.aeg.com
change the heat setting touch one of the
left / right control sensors.
To deactivate the function: touch
. The cooking zones operate
independently.
When you use only one cooking zone of
the pair we recommend that you use the
rear cooking zone. Also when you use
large cookware we recommend that you
put it near to the rear cooking zone.
4.6 Automatic Heat Up
Activate this function to get a desired
heat setting in a shorter time. When it is
on, the zone operates on the highest
setting in the beginning and then
continues to cook at the desired heating
setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch
Immediately touch a desired heat
setting. After 5 seconds
To deactivate the function: change the
heat setting.
4.7 Power function
This function makes more power
available to the induction cooking zones.
The function can be activated for the
induction cooking zone only for a limited
period of time. After this time the
induction cooking zone automatically
sets back to the highest heat setting.
Refer to "Technical
information" chapter.
To activate the function for a cooking
zone: touch
To deactivate the function: change the
heat setting.
4.8 Timer
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
single cooking session.
(
comes on).
comes on.
.
comes on.
First set the heat setting for the cooking
zone then set the function.
To activate the function or change the
/
time: touch
to set the desired time (00 - 99 minutes).
The function starts automatically. After 3
seconds the heat setting of the cooking
zone comes on the display.
To see the remaining time: touch
the desire cooking zone. The display
shows the remaining time.
To deactivate the function: touch
and then touch
counts back to 00.
CountUp Timer (The count up
timer)
You can use this function to monitor how
long the cooking zone operates.
To activate the function: touch
comes on the display. Touch again
activate the function. When this function
is active,
comes on. The display shows
how long the zone operates.
To deactivate the function: set the
cooking zone with
comes on the timer display and after 3
seconds the heat setting appears.The
symbol
goes out.
Minute Minder
You can use this function as a Minute
Minder when the hob is activated and
the cooking zones do not operate. The
heat setting display shows
To activate the function: touch
Touch
or
time. When the time comes to an end,
the sound operates and 00 flashes.
To stop the sound: touch
The function has no effect
on the operation of the
cooking zones.
4.9 STOP+GO
This function sets all cooking zones that
operate to the lowest heat setting.
and then touch
or
. The remaining time
. 00
and touch
.
.
of the timer to set the
.
for
to
. 00
Advertisement
Table of Contents
