Trigger Commands; Resetting The Custom Defaults - Honeywell N86 Series User Manual

the Minimum Message Length (MIN) is set to 2 characters;
the Maximum Message Length (MAX) is set to 60 characters;
and the Default setting (DFT) has no value.

Trigger Commands

You can activate and deactivate the engine with serial trigger commands. First,
the engine must be put in Manual Trigger Mode by scanning a Manual Trigger
Mode bar code (page 3-6), or by sending a serial menu command for triggering
(page 10-13). Once the engine is in serial trigger mode, the trigger is activated
and deactivated by sending the following commands:
Activate: SYN T CR
Deactivate: SYN U CR
The engine scans until a bar code has been read, until the deactivate command
is sent, or until the serial time-out has been reached (see "Read Time-Out" on
page 3-7 for a description, and the serial command on page 10-13).

Resetting the Custom Defaults

If you want the custom default settings restored to your engine, scan the Acti-
vate Custom Defaults bar code below. This resets the engine to the custom
default settings. If there are no custom defaults, it will reset the engine to the
factory default settings. Any settings that have not been specified through the
custom defaults will be defaulted to the factory default settings.
Activate Custom Defaults
The charts on the following pages list the factory default settings for each of the
commands (indicated by an asterisk (*) on the programming pages).
10 - 4