Marantz SR5014 Service Manual page 108

3-10. Error Code H1-12 failure detection procedure
Checking device. [U1040 : PCM9211]
Check the power supply voltage.
Check item(3-10.1.). Check the power supply volt-
age. :
Does the power supply voltage of the DIR [U1040]
indicate the appropriate voltage (3.3V)?
The test points are as follows.
3.3V
U1040
C2059
YES
DIR [U1040] is faulty.
Replace with a new device.
Recheck from check item (3.1.).
If it does not work, replace the PCB.
NO Check item(3-10.2.). Check the power supply volt-
age. :
Check the power supply components [U1067/
U1078] on the substrate and peripheral pattern.
If there is no problem, remove the DIR [U1040]
from the substrate and measure the voltage at
the test point of check item (3-10.1.).
Is the power supply voltage correct (3.3V)?
YES NO
The power supply circuit is faulty.
Replace the PCB.
Checking the reset waveform.
Check item(3-10.3.). Checking the reset :
Check the CPU.
Is the waveform of the TP near the DIR [U1040] correct (like the one
shown in the diagram) when the power is turned on?
RESET
32pin
U1040
YES NO
Check the reset circuit between CPU [U1018] and DIR [U1040].
If there is no problem, the DIR [U1040] is faulty.
Replace with a new device.
Recheck from check item (3.1.).
If it does not work, replace the PCB.
108
Examples of confirmation waveform
Voltage scale：1.0V/div
Time scale：20ms/div
Go to next page.