Table of Contents
Advertisement
Preparing for Installation
Preparing for Installation
This section provides information on safety, mounting the router, and unpacking the contents of the
router box.
Safety
This section provides safety warnings and electrostatic and router damage information for the Cisco 827
routers and SOHO 77 routers.
Warnings
Before installing the router, read the following warnings:
Warning
Only trained and qualified personnel should be allowed to install or replace this equipment.
Read the installation instructions before you connect the system to its power source.
Warning
Before working on a system that has a standby/off switch, turn the power to standby and unplug the
Warning
power cord.
Warning
Before working on equipment that is connected to power lines, remove jewelry (including rings,
necklaces, and watches). Metal objects will heat up when connected to power and ground and can
cause serious burns or weld the metal object to the terminals.
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
Warning
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Warning
If the symbol of suitability with an overlaid cross (
port to a public network that follows the European Union standards. Connecting the port to this type
of public network can cause severe injury or damage your router.
Cisco 827 and SOHO 77 Routers Hardware Installation Guide
2-2
) appears above a port, you must not connect the
Chapter 2
Installation
78-6854-03
Advertisement
Table of Contents
