Advertisement
1
If you choose to connect any external
devices such as sensors, alarms, etc., you
can connect them to the I/O terminal block.
(Please refer to the user's manual for I/O
voltages.)
2
Locate the network cable connector
(RJ-45 port) on the left-hand side of the
rear panel of the camera.
Ethernet cable to the port. Connect the
other end of the cable to the network.
Please
Note:
For
configuration, you will need to use a wired
connection.
After completing the setup
and configuration, you can begin using
your network camera wirelessly.
3
Locate the power input connector on
the left-hand side of the rear panel of the
camera and attach the external power
supply. To ensure the camera is powered
on, please check to see that the red
"Power/MIC" LED located on the black
plastic panel on the front of the camera is lit.
(To ensure a network connection, please
check to see that the green "Activity" LED
is lit or flashing.)
Connect an
initial
setup
and
1
2
3
9
Advertisement
