Table of Contents
Advertisement
Console
A VGA monitor with the highest resolution that you will be using on any PC in the
installation
A PS/2 Style Mouse
A PS/2 Style Keyboard
PC
The following equipment must be installed on each PC that is to be connected to the
system:
A VGA card.
Either a 6-pin mini-DIN (PS/2 style), or DB-9 (standard serial) mouse port.
Either a 6-pin mini-DIN (PS/2 Style) keyboard port with +5V DC on pin 4 and ground
on pin 3, or a 5-pin DIN (AT Style) keyboard port with +5V DC on pin 5 and ground
on pin 4.*
* See the note under Cables in the next section.
Cables
Depending on how many PC's you wish to configure, the following cables will be
required:
4 (CS164) HDB 15-pin male to male VGA Cables.
4 (CS164) PS/2 cables, male to male, for Keyboards.
4 (CS164) PS/2 cables, male to male, for the Mouse.
Note:
1. If your PC uses a standard AT style keyboard socket you will need to
purchase a PS/2-to-AT keyboard adapter in order to plug the cable into the
computer's keyboard port.
2. If your PC uses a standard 9-pin serial port for the mouse, you will need to
purchase a PS/2-to-Serial mouse adapter in order to plug the cable into the
computer's serial port.
3. Because of the wiring and pin assignments, you cannot use a Serial-to-PS/2
adapter at the end that plugs into the CS164/CS168. Therefore, attempting to
use a standard serial extender cable with adapters at both ends will fail.
(8 for the CS168)
(8 for the CS168)
(8 for the CS168)
- 5 -
Advertisement
Table of Contents
