Advertisement
7. Fit the strike plate. Rim
Position the strike plate on the door frame or
post so that it lines up with the latch bolt
Mark the door for the correct screw fixing position
If necessary cut a recess for the latch bolt
Once positioned and ready secure the strike to the
door frame or post with the fixing screws provided
8. How to change the hand of
the Slam Latch
The latch bolt is reversible.
It is held in position with a internal hex screw.
Loosen the hex screw with a hex key and this will
allow you to rotate the latch bolt 180° converting it
from one hand to the other.
9. How to change code
How to change your code
The code should be changed with the door/gate in the
open position. To change the code you will need to
know what the keypad is currently set to. The code can
be changed with the unit fitted on/off the door.
1. Enter existing code
2. Using code change key - insert into the hole in the
button - fully press and hold until step 5.
3. Press `C` button to clear the existing code.
4. Enter the new code.
5. Release the code change key from the hole in the
button.
6. Press `C` to set the new code.
7. The new code is now set and ready for use
8. Check that the code is working 5 times and that it is
withdrawing the latchbolt before closing the door/gate.
Please note: If a mistake is made whilst entering a
new code (with the * button pressed) the `C` button
can be pressed which will cancel any buttons that
have been pressed and you can start again.
BORG HELPLINE
+44 (0)1708 225700
0800 44 88 377
.3.
*
*
Advertisement
