Hawking HomeRemote HRNC1 User Manual page 35

Setting Wizard
Video Camera Name
IP Address
Subnet Mask
Gateway
Video Port
Cancel
Finish
When you finish with the camera settings, you can click "Ok" to run the "Camera Viewer" (i.e. recording software)
immediately or click "Cancel" to run the "Camera Viewer" later.
The default camera name is "HomeRemote Wireless Video Camera".
It is recommended that you enter a name for the camera that is easy to
remember.
The wizard will automatically set an available IP Address for the
camera. For example, if the IP address scheme for your network is
192.168.1.x, the wizard will search an unused IP Address between
192.168.1.0 and 192.168.1.254, and assign the camera an available IP
Address.
You may enter another IP Address to change the setting.
The wizard will auto-search the network's Subnet Mask setting and set
the camera to the same Subnet Mask.
You may enter another Subnet Mask to change the setting.
The wizard will auto search the network's router setting and set the
camera to use the same router.
You can enter another router to change the setting.
This defines the video stream port. The default port number is "5000".
Click "Cancel" to quit the Wizard Setting window.
Click "Finish" to complete the camera settings.
35