Remove And Then Replace An Ac Power Supply - Cisco Router ASR 1006 Hardware Installation Manual

Replace a Power Supply in a Cisco ASR 1006 Router, page 37
•
• Install and Remove the Shared Port Adapter, page 41
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Powering Off the Cisco ASR 1006 Router Safely
This section explains how to shut down the Cisco ASR 1006 Router. It is recommended that before turning off all power to the
chassis, you issue the reload command. This insures that the operating system cleans up all the file systems. Once the reload
operation is complete, then the Cisco ASR 1006 Router can be powered off safely.
To remove power from a Cisco ASR 1006 Router safely, follow this procedure and see the examples:
Slip on the ESD-preventative wrist strap that was included in the accessory kit.
Step 1
Step 2 Enter the reload command.
Confirm the reload command:
Step 3
Rmcp-6ru-1#reload
Proceed with reload? [confirm]
Aug 17 00:06:47.051 R0/0: %PMAN-5-EXITACTION: Process manager is exiting: prs exit with reload chassis
code
After confirming the reload command, wait until the system bootstrap message displays before powering off the system.
Step 4
System Bootstrap, Version 12.2(33r)XN2, RELEASE SOFTWARE (fc1)
Technical Support: tap://www.cisco.com/techsupport
Copyright (c) 2010 by cisco Systems, Inc.
Current image running: Boot ROM0
Last reset cause: LocalSoft
ASR1000-RP1 platform with 4194303 Kbytes of main memory
mcp-6ru-1-rp0-rommon 1>
Remove any power cables from the Cisco ASR 1006 Router.
Step 5
a. For power supplies with a circuit breaker switch, position the switch to the Off (O) position.
b. For power supplies with a standby switch, place the standby switch in the Standby position.
After powering off the router, wait a minimum of 30 seconds before powering it on again.
Note
Replace a Power Supply in a Cisco ASR 1006 Router
This section provides instructions for removing and replacing the AC power supply and the DC power supply in a Cisco
ASR 1006 Router. Before you begin, make certain the chassis is grounded.

Remove and Then Replace an AC Power Supply

To remove a live Cisco ASR 1006 Router AC power supply that is not operating normally (and then replace the AC power supply
within five minutes), follow this procedure:
37