Panasonic PV-M1348 Service Manual page 50

How to adjust:
1. Press CH UP/DOWN key on the remote control to select
control function to be adjusted.
Important Note:
Make a note of the original value of the controls before
modifying in case the wrong control is adjusted.
2. Press VOL UP/DOWN key on the remote control so that the
shaded area moves to the value.
00
SUB TINT
Fig. E4-2
3. Press CH UP/DOWN key on the remote control to adjust
the value of the selected control.
00
SUB TINT
Fig. E4-3
Note:
You can select a desired channel by using the numbered
keys on the remote control in EVR adjustment mode.
4. Press VOL UP/DOWN key on the remote control so that the
shaded area moves to the control function.
07
SUB TINT
Fig. E4-4
5. Press CH UP/DOWN key on the remote control to select a
control function for the next adjustment if necessary.
07
SUB TINT
Fig. E4-5
How to release from EVR Adjustment Mode:
Press and hold STOP, FF, and VOL DOWN buttons on the unit
together over 5 seconds again or press the POWER button
OFF.
The adjusted value will be written to Memory IC (IC6004).
00
SUB TINT
Adjust
07
SUB TINT
07
SUB TINT
00
SUB COLOR
2-27
HOW TO ENTER EVR PG SHIFTER
ADJUSTMENT MODE
1. Enter EVR adjustment mode.
2. Insert the VHS Alignment Tape and playback in SP mode.
The adjustment overlay will appear.
PG SHIFTER
Fig. E4-6
How to adjust:
Press CH UP/DOWN key on the remote control to adjust the
value.
PG SHIFTER
Fig. E4-7
How to release from EVR PG Shifter Adjustment
Mode:
Press STOP button or press the POWER button OFF.
The adjusted value will be written to Memory IC (IC6004).
HOW TO ENTER SERVICE MODE
1. Enter EVR adjustment mode.
2. Press DISPLAY key on the remote control for collapse
scan.
Note:
Before pressing DISPLAY key on the remote control for
collapse scan, select the desired control function and move
the shaded area to the value for adjustments you will
proceed.
00
SUB COLOR
Fig. E4-8
How to release from Service Mode:
Press DISPLAY key again on the remote control.
Value to be
adjusted
80
Adjust
81