Panasonic PV-M1348 Service Manual page 25

VCR Unit
Disassembly Procedure
1. Discharge the Anode to the CRT Ground. Then, remove the
Anode Cap.
2. Disconnect the Connector P354 from the CRT C.B.A.
3. Carefully pull out the CRT C.B.A. from the CRT Unit.
4. Disconnect the Deflection Yoke Connector and the
Degaussing Coil Connector from the TV Main C.B.A.
5. (Model : A, B, C, D, E, F, G, H, I, J)
Disconnect the Connector P4592 on the Main C.B.A. and
remove the leads from the clampers.
(Model : K)
Disconnect 2 Connectors P4604 and P4605 on the Stereo
Amp C.B.A. and remove the leads from the clampers.
Anode Cap
TV
P4605
(Model : K)
Clampers
Main
C.B.A.
P4592
(Model : A, B, C,
D, E, F, G, H, I, J)
Deflection
Yoke
Connector
Fig. D3-1
6. (Model: A, B, C, D, E ,F)
Slightly lift up the rear side of the VCR Unit to release 2 Tabs
(B).
(Model: G, H, I, J, K)
Slightly lift up the rear side of the VCR Unit to release 4 Tabs
(B) and (C).
7. Slide the VCR Unit out as far as it will go.
Then, lift up the VCR Unit to release 3 Guide Tabs (A) and
remove the VCR Unit all the way out from the TV cavity.
CRT C.B.A.
CRT Unit
P354
Stereo Amp
C.B.A.
(Model : K)
Clamper
Degaussing
P4604
Coil Connector
(Model : K)
2 VCR Unit
TV Main C.B.A.
Holes (A)
VCR Unit
VCR Unit
Bottom view of VCR Unit
Reassembly Notes
Installation of VCR Unit
1) When installing the VCR Unit, swing the Cassette Door-Lid
all the way open until the Cassette Door tab clears the
Opener Lever.
2) Make sure that all guide tabs are aligned properly. Then,
press the VCR unit in.
Cassette Door-Lid
CAUTION
View "A"
Cassette Door Tab
Opener Lever
2-2
Guide Tabs (A)
Tabs (B)
Tabs (C)
Fig. D3-2
CAUTION
VCR Unit
Cassette Door-Lid
Fig. D3-3
Press
View "A"