Hatco POWERMITE PMG-100 Datasheet

Altitude: ft. above sea level 0 – 2000
PMG-60
Approved Input Rate:
Suggested Orifice Size:
GPH Capacity Derate:
PMG-100
Approved Input Rate:
Suggested Orifice Size:
GPH Capacity Derate:
PMG-200
Approved Input Rate:
Suggested Orifice Size:
GPH Capacity Derate:
Notes:
This is the maximum allowable btu rate certified by AGA. These are to be verified by the qualified gas installer on site. Check Heat Value with local Gas Utility.
The first orifice size is the factory built unit.
The next sizes are shown at the altitudes where a change is required to allow pressure adjustments to the approved input rates.
This is a derate multiplier to use when sizing a gas booster for a given application.
Take this value and multiply it by the GPH found on the Hatco sizing chart to insure it will provide the capacity you need.
You can also use this value by dividing it into your capacity needs and take the resulting adjusted GPH to the sizing chart to select a gas booster.
2001-3000 3001-4000
58000 56154 54308
#55DMS
1 0.97
105000 103363 101726
#34DMS
1 0.98
195000 171600 163800
#35 DMS #36DMS
1 0.88
ALTITUDE SUMMARY
PUBLICATION DATA FOR POWERMITE
NATURAL GAS
4001-5000 5001-6000
52462 50615
#56DMS
0.94 0.90 0.87
100089 98452
0.97 0.95 0.94
156000 148200
#37DMS
0.84 0.80 0.76
®
GAS BOOSTERS
6001-7000 7001-8000 8001-8500
48769 46923
0.84 0.81
96815 95178
0.92 0.91
140400 132600 128700
#38DMS #39DMS #40DMS
0.72 0.68
8501-9500 9501-10500
46000 44160 42320
0.79 0.76 0.73
94360 90585 86811
0.90 0.86 0.83
123552 118404
#41DMS #42DMS
0.66 0.63 0.61