Advertisement
3. SPECIFICATION
Model: ..........................................................................................PPF301S ............................................................... PPF501S
Air Consumption: ............................................................................. 4.5cfm ....................................................................4.5cfm
Bench or Floor Mounting: ....................................................................Floor ...................................................................... Floor
Capacity: ........................................................................................ 30tonne ................................................................. 50tonne
Gauge Included: .................................................................................... Yes ........................................................................ Yes
Lateral Ram Travel: ......................................................................... 200mm .................................................................. 280mm
Maximum Height - Ram to Table: .................................................... 875mm .................................................................. 860mm
Minimum Height - Ram to Table: ....................................................... 25mm .................................................................... 80mm
Overall Height: .............................................................................. 1800mm .................................................................1900mm
Overall Width: ................................................................................. 770mm .................................................................. 930mm
Ram Diameter: ............................................................................. Ø102mm ................................................................Ø121mm
Ram Stroke: .................................................................................... 145mm .................................................................. 145mm
Screw Extension: .............................................................................. 75mm .................................................................... 75mm
Table Aperture: ................................................................................ 168mm .................................................................. 224mm
Total Ram Travel: ............................................................................ 220mm .................................................................. 220mm
Type: ...................................................................................................Floor ...................................................................... Floor
Working Pressure:.................................................................. 130.5-174psi ..........................................................130.5-174psi
Working Table Depth: ...................................................................... 188mm .................................................................. 248mm
Working Table Width: ...................................................................... 710mm .................................................................. 930mm
4. ASSEMBLY
Unpack the product and check contents. Should there be any damaged or missing parts contact your supplier immediately.
▲
DANGER! Take care to ensure safety when moving main frame from packing as the unit is very heavy. Use a suitable hoist or
gantry.
Refer to attached parts list.
Seek assistance from another person on assembly of heavy parts.
Assemble press, if possible, in close proximity to where the press will be located.
4.1.
ATTACH SUPPORT FEET
4.1.1.
Attach load slings around the top cross member of the frame and using a suitable hoist or gantry, slowly, and in a controlled
manner lift the frame up and out of the transportation crate, into an upright position.
WARNING! Take care when lifting the frame not to damage the pre-assembled ram assembly, pump assembly, bed frame
‰
assembly and winch assembly.
4.1.2.
Keep the frame assembly in an upright position, held safely by the load slings.
▲
DANGER! DO NOT allow the frame to fall over.
4.1.3.
Select the support foot with the foot pump attached (fig 1 #49) and locate to the lower right side of press base frame (fig 1 #4).
4.1.4.
Locate inner vertical edge of support foot with cut-out in frame and secure with bolts (fig 2 #11), nuts (fig 2 #12) and washers
(fig 2 #71).
4.1.5.
Repeat for left hand side support foot (figs 1, 2 #10).
4.1.6.
It is recommended that, for safest operation, that the press is secured to the floor using the fixing holes in the feet.
fig.1
fig.3
© Jack Sealey Limited
fig.4
fig.6
Original Language Version
fig.2
fig.5
PPF301S, PPF501S Issue:2 (3)27/06/22
Advertisement
