Panasonic PVQ-1312W Service Manual page 172

*Important: If a remote control button does not work when pressed, press the COMBO button
on the remote and try the button again.
Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few seconds
to cancel the Timer Recording.
• Any future daily or weekly recordings
will be performed as programmed.
Model PV-C2062 remote shown.
Review, Replace or Clear Program
Contents :
1
2
3
SELECT/SET
:CH UP
:CH DOWN
:VOL UP
:VOL DOWN
PROG
ADD/DLT
STOP
4
Notes
• 2 minutes before Timer recording is performed,
• If the start times of two programs overlap, the lower
• If the start time for a Timer Recording comes up during
• If there is a power interruption of more than one minute,
• If "INCOMPLETE" appears after all items have been
(Recording is not in progress)
Repeat steps 1 and 2 on page 22.
P DT START STOP CH SPD
1 day day 9 9 : 00 00p 12 12 : 00 00a 08 08
2 8 10 : 00a 12 : 00p 125
3 10 8 : 00p 9 : 00p 10
4 SU 9 : 00p 10 : 00p L
CANCEL : ADD / DLT
SELECT 1 - 8 :
ENTER :
END : PROG / ACT I ON
To Replace program...
DATE START STOP
8 SAT SAT 9:00 00P P 12 12: 00 00A 08 08
TODAY
----------------------------------------------
SE SELE CT START START DAT ATE
SELECT :
SET :
END : PROG / ACT I ON
To Clear program...
P DT START STOP CH SPD
1 -- -- -- -- : -- -- -- -- : -- -- -- --
2 8 10 : 00p 12 : 00a 125
3 10 8 : 00p 9 : 00p 10
4 SU 9 : 00p 10 : 00p
SELECT 1 - 8 :
ENTER :
END : PROG / ACT I ON
Press PROG twice (or ACTION)
to exit this mode.
"PLEASE PREPARE FOR TIMER REC" appears and/
or the PROG TIMER Indicator flashes. Be sure a
cassette with record tab is loaded and the unit is in
Stop mode.
numbered program will have priority.
a normal recording or One Touch Recording (page 12),
the Timer Recording will not be performed.
the recording may not be performed or continued.
set, check all entries and make necessary corrections.
Press to select
SP SP
the desired program.
SP
SP
LP
1) Press to display.
CH
2) Press
ABC
and press
SP
to set new program
contents.
3) Press PROG (or
ACTION).
Press ADD/DLT.
-- --
SP
SP
L LP
to select
or
23