Panasonic PVQ-1312W Service Manual page 158

*Important: If a remote control button does not work when pressed, press the COMBO button
on the remote and try the button again.
Manual Clock Set
If AUTO CLOCK SET was incomplete, manually
set the clock as follows.
1
Press ACTION on the Remote to
display SET CLOCK Menu screen.
1 / /
SE SELE CT MONTH
SELECT :
SET
END
2
Press to select the month
and press
manner, select and set the date,
year, time, and DST. (Daylight
Saving Time)
SET CLOCK
2 / 6/ 2 / 6/
SET COMPLETED SE COMPLETED
SET
START
3
Press ACTION twice to start
CLOCK and exit.
POWER
ACTION
Model PV-C2062 remote shown.
SET CLOCK
:
DST : ON
TH
:
: ACT I ON
to set. In the same
:
2002 2002 WED WED 12 12 00 00PM PM
DST : ON
:
: ACT I ON
SELECT/SET
:CH UP
:CH DOWN
:VOL UP
:VOL DOWN
Reset all unit Memory Functions
When moving unit to a new location, or if a
mistake was made in the Initial Setup section.
• Make sure a tape is not inserted in the unit.
POWER POWER VOL VOL
VIDEO IN VIDEO IN AUDIO IN AUDIO IN
1 Turn the unit
Power on.
2 Press and hold both PLAY and
FF on the unit for more than 5
seconds.
• The power will shut off.
• Please ignore "NO CASSETTE" warning.
3
Do "Initial Setup" on page 8.
Note to CABLE System Installer
This reminder is provided to call the
CABLE (Cable TV) System Installers
attention to Article 820-40 of the NEC
that provides guidelines for proper
grounding and, in particular, specifies
that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
CH CH STOP/EJECT REW/ STOP/EJECT REW/ PLAY/REPEAT FF/ PLAY/REPEAT FF/ REC TIMER/FM REC TIMER/FM
REC ON TIMER PROG TIMER REC ON TIMER PROG TIMER
ACTION ACTION
9