Checking The Setup Procedures; Peer-To-Peer Printing - Develop NC-5 User Manual

Getting Ready
2.2

Checking the Setup Procedures

This section describes the required procedures for setting up network
printing for the selected network print method.

Peer-to-Peer Printing

1
Check that all of the accessories have been included in the package.
("3 Checking the Accessories")
2
Connect the network cable. ("4 Connecting the Network Cable")
3
Specify the IP address, subnet mask, and default gateway settings for
the copier. ("5 Assigning an IP Address")
4
Print the Configuration Page and check the settings. ("6 Printing the
Configuration Page")
Note
The Configuration Page cannot be printed for copiers that are not
equipped with the fax function.
5
Install the printer driver. The Peer-to-Peer Utility is installed when you
install the printer driver.
❍ For details on installing the printer driver, refer to "PCL PRINTER
CONTROLLER" or "GDI PRINTER CONTROLLER" in the manual
provided with the copier.
6
Add a network port to the computer. ("7 Connecting the Computer and
Copier")
NC-5
2
2-7