Maintenance; Figures (Illustrations) - RIDGID Power Stroke PSL0D181 Operator's Manual

INSTALLING/REMOVING BITS
See Figures 3 - 4, page 7.
The tool has a built-in coupler that is designed to accept
1/4 in. hex bits.
NOTE: Bits are not included.
To install bits:
 Lock the switch trigger and remove the battery pack.
 Slide the coupler forward and hold in position.
 Insert bit straight into coupler.
 Slide the coupler back slowly and release.
 Reinstall the battery pack.
WARNING:
Make sure the bit is secured in the coupler before using
the impact driver. Failure to do so could cause serious
personal injury.
To remove bits:
 Lock the switch trigger and remove the battery pack.
 Slide the coupler forward and pull the bit straight out of
the coupler.
 When not in use, bits can be placed in the storage area,
located on the base of the tool.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
Figures (Illustrations) start on page 8 after French and Spanish language sections.
OPERATION

MAINTENANCE

This product has a Three-year Limited Warranty.
For Warranty details go to www.powerstroketools.com
USING THE IMPACT DRIVER
See Figures 5 - 6, page 7.
WARNING:
Do not drive a screw where there is likely to be hidden
wiring behind the surface. Contact with a "live" wire will
make exposed metal parts of the tool "live" and shock
the operator. If you must drive a screw where hidden wire
may be present, always hold tool by insulated gripping
surfaces (handle) when performing the operation to
prevent a shock to the operator.
WARNING:
The metal surface can become hot during use. Avoid
contact with it to avoid possible burn injury.
NOTICE:
The impact driver is not designed to be used as a drill.
 Check the direction of rotation selector for the correct
setting (forward or reverse).
 Hold the impact driver with one hand.
 Place the bit on the screw head and slowly depress the
switch trigger. Start the bit slowly for more control.
 As screw is driven, impacting will begin.
BATTERY PACK REMOVAL AND
PREPARATION FOR RECYCLING
WARNING:
Upon removal, cover the battery pack's terminals with
heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its compo-
nents. Batteries must be recycled or disposed of properly.
Also, never touch both terminals with metal objects and/
or body parts as short circuit may result. Keep away from
children. Failure to comply with these warnings could
result in fire and/or serious injury.
Page 6 — English