Table of Contents
Advertisement
[MC Test Mode]
• This mode is used to check operations of the respective sections
of Amplifier, Tuner, CD and Tape.
Procedure:
1.
Press the ?/1 button to turn on the set.
Press the three buttons of x , DISPLAY and DISC 3
2.
simultaneously.
3.
A message "TEST MODE" appears on the FL display tube.
When f (STIC UP) button is pressed, GEQ increases to its
4
maximum and a message "GEQ MAX" appears.
5.
When F (STIC DOWN) button is pressed, GEQ decreases to
its minimum and a message "GEQ MIN" appears.
6.
When g (STIC LEFT) or G (STIC RIGHT) button is pressed,
GEQ is set to flat and a message "GEQ FLAT" appears.
7.
When the VOLUME control knob is turned clockwise even
slightly, the sound volume increases to its maximum and a
message "VOLUME MAX" appears for two seconds, then the
display returns to the original display.
8.
When the VOLUME control knob is turned counter-clockwise
even slightly, the sound volume decreases to its minimum and
a message "VOLUME MIN" appears for two seconds, then
the display returns to the original display.
9.
In the test mode, the default-preset channel is called even when
the TUNER is selected and an attempt is made to call the preset
channel that has been stored in memory, by operating the Shuttle
knob. (It means that the memory is cleared.)
10. When CD is selected and press MODE SELECT , and press
ENTER when "Set up Mode" is displayed.
Press ENTER when "CD Set up?" is displayed.
Move the stick left and right to display "CD Edit Start?", and
press ENTER , the disc that is being chucked at this moment
becomes the default setting. It means that the default disc only
is accessed when any other discs are selected even though the
display indication changes accordingly. At the same time, the
Z1 to Z5 cannot be accepted. (It means that the tray motor
and the turntable motor are disabled of their operation.)
11. When a tape is inserted in Deck B and recording is started, the
input source function selects VIDEO automatically.
12. When x button is pressed to stop recording, the Tape (Deck)
B is selected and tape is rewound using the j button, tape
is rewound, tape is stops at around the record-starting position
and playback of the recorded portion of the tape is started. If
PAUSE is inserted even once during recording, tape is rewound
to the position around the PAUSE position and is played back.
13. When the HI-DUB Button is press during playback of Deck
B, either normal speed or high speed can be selected by this
button.
14. Select the desired loop by pressing MODE SELECT , and
press ENTER when "Set up Mode" is displayed.
Press ENTER when "CD Set up?" is displayed.
Move the stick left and right to display "Tape Set Up?", and
press ENTER .
Press ENTER when "Direction Set Up?" is displayed.
Move the stick left and right to display "Cycle?", and press
ENTER .
Insert a test tape AMS-110A or AMS-RO to Deck A.
15. Press the CD SYNC button to enter the AMS test mode.
16. After a tape is rewound first, the FF AMS is checked, and the
mechanism is shut off after detecting the AMS signal twice.
17. Then the REW AMS is checked and the mechanism is shut off
after detecting the AMS signal twice.
18. When the check is complete, a message of either OK or NG
appears.
19. When you want to exit this mode, press the ?/1 button twice.
The cold reset is enforced at the same time.
15
Advertisement
Table of Contents
