Operation - Handler Red Wing 26 Manual

Chuck/Changer Kit Care and Other Information
!
CAUTION
DO NOT attempt to operate Chuck/Changer unless it is
properly installed on lathe.
NEVER oil or use solvents of any kind on Chuck/Changer
NEVER close collet without a tool (chuck.burr, etc) in the
collet. Allow clutch spring to engage clutch (Never push up
on handle or let handle snap up.l
DO NOT remove or attempt to defeat the purpose of the
safety strap.

OPERATION

Normal running position, handle 9: 15 o'clock to 10:30
o'clock.
To disengage clutch, bring handle down to 8:00 o'clock
position, counter-clockwise.
To apply brake, bring handle down to approximately 7:00
o'clock position, counter-clockwise.
NOTE: Brake position is used for changing arbor bands,
buffing wheels, etc. To open collet, bring handle straight
down to 6:00 o'clock position, Tools (chucks) burrs, etc.,
may be changed while handle is in straight down (6:00
o'clock) position.
OVERHEATING
A new or rebuilt Chuck/Changer
will normally run quite warm (very
uncomfortable to the touch) during
the break in period. The break in
period will usually last several
weeks depending upon speed and
amount of use. Worn collects, collets
not screwed in all the way or too
long a stop will cause overheating,
especially in the front portion of the
Chuck/Changer.
6
USE OF 3/32" DIAMETER SHANK TOOLS IN Chuck/
CHANGER
1. With handle straight down, insert tool in inner collet to
2. Move handle clockwise to approximately 8:00 o'clock
3. Never push up on handle.
USE OF 1/4" DIAMETER SHANK TOOLS IN Chuck/
CHANGER
1. With handle straight down, insert chuck shank into
NOTE: The inner collet will be pushed back inside Chuck/
Changer
2. While holding tool in collet, move handle clockwise to
3. Remove hand from tool and allow clutch spring to
4. Never push up on handle.
REMOVE CHUCK FROM LATHE
Always move handle straight down
(6:00 o'clock) and leave it in this
position if you have any reason to
remove the chuck from the lathe.
If handle is moved, the clutch
spring may be damaged or clutch
spring tension may be released.
When clutch spring is damaged
or tension released clutch will not
engage properly. See instructions
under Clutch Spring Adjustment and
replacing clutch spring. Normally
it is not necessary to remove the
adapter or clutch from the lathe
when you return the chuck to the
factory for repair. If it is necessary
to remove adapter or clutch refer
to the installation instruc tions for
your particular model lathe. Serious
damage to clutch or adapter will
result if instructions are not followed.
desired depth.
position. Remove hand from tool and allow clutch spring
to return handle to running position.
outer collet.
approximately 8:00 o'clock position.
return handle to running position.
SQUEAKING CLUTCHES
After several months of service,
a clutch may glaze and develop a
squeak. The squeak is usually most
noticeable as the lathe is coasting
to a stop. Remove chuck from lathe
(see instructions under removing
chuck from lathe) and lightly sand
both fiber and steel clutch surfaces.
If squeaking persists and there is
a presence of excessive amounts
of dust around the clutch area, the
adapter is improperly mounted,
causing misalignment of the clutches.
Refer to installation instructions for
your model lathe.