Handler Red Wing 26 Manual page 5

Chuck/Changer Installation
i
Chuck/Changer Comes Installed on models 16B and 16B-1.
Kit available for purchase separately SKU:16
Fig 1
1. Remove the chuck remover
completely from the right side (or
for the left handed Chuck/ Changer)
of the lathe (See Fig. 1 )
2. Remove the red polymer cap from
the motor hub. Sand and/or scrap
all paint from 2" diameter lathe
hub using the emery cloth
provided. (See Fig, 3)
Fig 4
6. With Chuck/Changer handle in
6 o'clock position, place Chuck/
Changer with hub adapter on to
lathe hub.
NOTE: A slight pressure may be
necessary to accomplish this
procedure Tighten set screw in Chuck/
Changer's hub adapter, evenly
See video on YouTube https://www.youtube.com/watch?v=3dH1F-eu8DU
Fig 2
3. Using emery cloth remove burs,
rust or paint from the 1 /2" portion
of the motor shaft.
4. Slide clutch onto the right side shaft
of the motor. The large diameter of
the aluminum portion of the clutch
should be positioned approximately
1/16" from the 2" hub. (See Fig. 4)
Fig 5
7. Slowly rotate chuck handle
clockwise, to 9:30 o'clock position
Allow handle to ease into position.
Should the handle stop beyond the
10:30 o'clock position, the chuck
has not been "slid" on to the hub
properly. (Place the handle in the
6 o'clock position and repeat Step
6 above, pushing the entire
assembly towards the lathe.
8. Having adjusted the clutch handle
into the proper position, secure all
set screws on the adapter.
Fig 3
Pressure
applied
here
5. Tighten set screw to mark the shaft
slightly. Loosen set screw and
remove clutch. File a small flat
section where clutch screw. Lightly
sand tiled portion to remove the
bur, caused by filing. Replace clutch
tightening set screw securely.
Fig 6
9. The operating range of the clutch
handle is 6:00 o'clock counter-
clockwise to OPEN the collets and
9:30-10:30 o'clock to CLOSE collets
MAKE CERTAIN never to close the
collets without a tool in it
10. Clean collets every 30 days.
Lubricating outside of collets with
a LIGHT coat of silicone grease-
ONLY. Always keep a tool in the
collets so the hardened collets will
not take a smaller diameter set
Set
screw
5