10
Tasks performed by BrainLAB
The following tasks are performed by a BrainLAB technician trained for the Siremobil,
without the presence of a SIEMENS technician:
•
Install and start up the navigation system
•
If necessary, adapt the DICOM network node to the Siremobil Iso-C
•
Check network communication between 3D PC and navigation system
•
Calibrate 3D reconstruction on Siremobil Iso-C with marker ring installed
•
Check 3D high resolution on Siremobil Iso-C
•
Create a backup CD
•
Turnover to customer, customer briefing
Procedure in collaboration with all other navigation systems vendors
There is a time overlap involving the Siemens technician and the navigation sys-
tems vendor's technician
In such cases, the Navilink interface installation can be only partially performed by a SIE-
MENS technician. Some tasks must be carried out in close cooperation with a technician
from the navigation systems vendor.
This means that the SIEMENS technician requires two service calls to integrate the navi-
gation system.
Tasks performed by Siemens
•
Schedule the service call with the customer.
Siemens technician (1st service call)
The following tasks must be performed by the SIEMENS technician at the 1st service call:
•
Check all required system updates and perform any that are still necessary
•
Install the new grid holder on the image intensifier
•
Check latest SW version, and install if necessary
•
Check Navilink license, and install if necessary
•
Configure a default DICOM network node for the navigation system
•
Calibrate 3D reconstruction. Only the calibration without the navigation system can be
performed, since the navigation system's marker ring is not present.
•
Check image quality and 3D high resolution
SIREMOBIL Iso-C 3D
SPR2-230.814.03.02.02
11.05
General information
Page 10 of 52
CS SD 24
0
Siemens AG
Medical Solutions