Advertisement
Step 2
Unfolding the handlebars
Put down the kickstand so the bike stands up
without you having to hold it. Your Charge will
travel with the handlebars folded.
To unfold, simply lift the bars up into place from
its hinges. Straightn the lever so it locks into
place. There should and will be sme resistance as
the locking mechanism secures.
Pull around the safety catch so the bars are
properly secutred. This safety catch will again be
a little resistant, but is important for re-enforcing
the handlebars and should wlays be fixed on
when riding.
If the handlebars and the fork aren't alligned,
you can adjust this by removing the rubber bung
at the top of the bars, loosing the allen key bolt
slightly. Stand in front of the bike with the wheel
inbetween your knees and gently rotate the bars
to align with the wheel. Tighten the bolt back up
and pop the bung back in place.
To change the rotation of the handlebars, simple
loosen the 4 bolts on the stem plate, rotate the
bars to your prefered riding position, and tighten
the bolts back up. When tighteening, use a cross
sequence to ensure even pressure is applied so
the stem can sit flush.
To extend the handlebars, open the quick release
lever on the handlebar tube and extend the inner
tube to your desired height. Close the lever to
secure in place.
There should be resistance agianst the lever to
make sure the handlebars are secure. If more
resistance is required, simply open the lever,
tighten the nut on the other side by a rotation or
two, and close the lever again.
Step 3
Unfold the pedals
Your pedals will arrive folded inwards. To unfold,
simply push the main casing of the pedal inwards
and flip down. It is important not to force the
pedal down to avoid damaging any of the pedal
components.
Advertisement
