Panasonic EH-XC10 Operating Instructions Manual page 14

4
4
After the make‑up remover has loosened the
make‑up, press the warming make‑up removal
switch to turn off the power.
• Make sure to clean the appliance with a tissue or
wash with water after every use. (See pages 16
and 17.)
• The appliance will turn off automatically
approximately 3 minutes after the warming make-
up removal mode indicator begins glowing.
Brush cleansing
Remove dead skin and dirt from pores with the gentle
fine brush and microfoam.
If you are still wearing make-up, first remove the make-
up using the warming make-up removal mode or remove
eye make-up with your hands.
1
1
Attach the soft brush by
pressing it until it clicks into
place.
2
2
Open the facial cleanser
compartment and add facial
cleanser. (See page 12.)
Add the recommended amount as
indicated on your facial cleanser
product (the amount you normally
use).
14
PB017051 - EH-XC10 _(01EN)_11-19-18.indd 14
3
3
Fill the measuring cap with
water (approximately 4 mL)
and pour into the center of
the brush.
Notes
• Use a foaming facial cleanser.
• Depending on the type of facial
cleanser (sticky facial cleansers,
etc.) or the amount used, the facial
cleanser may not mix properly and
clog the appliance. In rare cases,
power to the appliance may be
interrupted. (See page 18.)
• The quality of foam varies depending on the type of
facial cleanser. Adjust to the recommended amount
as indicated on your facial cleanser product, or adjust
the amount of water.
• Do not add anything other than facial cleanser into
this appliance. (Doing so may cause malfunction.)
• If you are using a non-foaming type facial cleanser,
moisten the brush and your face with water and
apply the facial cleanser directly onto your skin.
• Please pour liquid facial cleansers and the like
into the center of the brush. (Facial cleanser may
come out from the holes on the front side of the
main body when you pour it from the facial
cleanser compartment.)
4 mL
2018/11/19 8:41:31