Group 8 Turning Joint - Hyundai HX140L Manual

GROUP 8 TURNING JOINT

1. REMOVAL AND INSTALL
REMOVAL
1)
Lower the work equipment to the ground
(1)
and stop the engine.
Operate the control levers and pedals
(2)
several times to release the remaining
pressure in the hydraulic piping.
Loosen the breather slowly to release the
(3)
pressure inside the hydraulic tank.
Escaping fluid under pressure can
penetrate the skin causing serious injury.
When pipes and hoses are disconnected,
the oil inside the piping will flow out, so
catch it in oil pan.
Disconnect all hoses.
(4)
Sling the turning joint assembly (1) and
(5)
remove the mounting bolt (2).
Weight : 50 kg (110 lb)
Tightening torque : 12.3 1.3 kgf m
Remove the turning joint assembly.
(6)
When removing the turning joint, check
that all the hoses have been disconnected.
2) INSTALL
(1) Carry out installation in the reverse order
to removal.
Take care of turning joint direction.
Assemble hoses to their original positions.
Confirm the hydraulic oil level and check
the hydraulic oil leak or not.
(88.9 9.4 lbf ft)
8-137
1
1
2
13031GE18
14098TJ01
14098TJ02