Application; Intended Use; Non-Intended Use - Leister VACUUM PLATE 300 Operating Instructions Manual

Caution
Risk of burns
The device may only be operated at intervals. If the on duration is too long (>2min), the temperature
on the motor housing can cause burns. Always allow the device to cool down. The device can only
be operated using the handles and switches provided. The main switch must be switched off in the
event of a mains voltage failure.
The device should only be operated by trained specialists or under their supervision. Children are not
permitted to operate the device.
Be aware of hazards in the surrounding area, e.g., risk of tripping, risk of slipping, strong sunlight,
unattended equipment, etc.
Note
The local supply voltage must match the nominal voltage specified on the device. Incorrect mains
voltage can cause the device to fail. The main switch must be switched off in the event of a mains
voltage failure.

2. Application

2.1 Intended use

The VACUUM PLATE 300 is intended for professional use and is used to check the weld seams for leaks.
The VACUUM PLATE 300 is intended for generating a vacuum in interval operation for max. 2 minutes ON/30
seconds OFF.
Material types and material thicknesses
The VACUUM PLATE 300 can be used for testing various material types such as PE-HD, PE-LD, TPO/FPO, PP and
PVC. The permissible material thicknesses of the indicated materials are 1 – 3 mm.
Use only original Leister spare parts and accessories; otherwise, any warranty or guarantee claims will be invali-
dated.

2.2 Non-intended use

Any other use or any use beyond the type of use described for the VACUUM PLATE 300 is deemed non-intended use.
Test operation is not permitted in case of condensation (e.g. rain).
4