Before Use; Operation; Display; Setting The Pressure - Mistral MSP 12 A1 Original Instructions Manual

■ Before use, check the cigarette lighter to make
sure there is no rust or residue in it . If the cigarette
lighter socket has poor electrical conductivity,
this may cause the product or the power source
to overheat, resulting in damage to the product .

Before use

♦ Pick up and carry the appliance using the
carrying handle .
♦ Plug the 12 V vehicle connector plug
suitable socket in your vehicle . The display
lights up and the appliance is ready for use .

Operation

NOTE
► The appliance vibrates during operation .
Therefore, always put it down during opera-
tion . There are four feet
the appliance for this purpose .
ATTENTION!
► This appliance is not designed for continuous
operation. The appliance may be used for a
maximum of 10 minutes continuous operation .
Allow the appliance to cool down completely
and then try using it again .
♦ Select the accessories you need .
♦ Remove the hose
is secured for transport and storage with the
elastic band .

Display

♦ You can switch between "bar", "psi" and "kpa"
on the display by pressing the selection
button .
■ 6 │ GB │ IE │ NI │ CY
into a
on the bottom of
from the appliance . This

Setting the pressure

♦ Press the "+" button
set the desired pressure .
TIP
► If you press and hold down the "+" button
or the "-" button
changes quickly .
NOTE
► The compressor switches off automatically
when the preset pressure has been reached .

Switching on and off

Switching on the appliance
♦ Press the ON/OFF switch
Switching off the appliance
♦ Press the ON/OFF switch

Setting up

Inflating/deflating

♦ Fit the locking connection of the hose
the desired adapter . To inflate, use the inflation
connection . To deflate, use the deflation
connection .
♦ Turn it clockwise until it is fixed firmly in place .

Attachments

♦ Screw the adapter
tion of the hose anticlockwise until it is fixed
firmly in place .
♦ Screw the adapter
connection of the hose
fixed firmly in place .
♦ Push the desired adapter into your SUP board
and follow the manufacturer's instructions .
High-pressure attachment
The high-pressure attachment makes it easier to fill
SUP boards .
The middle seal, which is preassembled on the
adapter, is used as standard .
If air leaks occur during operation, please use the
thickest gasket . If you cannot insert the attachment
into the object, please use the thinnest seal .
or the "-" button to
, the pressure setting
.
again .
onto
onto the adapter connec-
or onto the adapter
clockwise until it is
MSP 12 A1