Table of Contents
Advertisement
the output mode of the points output trigger wire.
This must be set correctly for your type of ignition for
the unit to operate properly. If not set properly, the
engine may not run or could misfire.
Mode configures the unit for the specific ignition
system you are using. You must select the proper
mode for your ignition for the unit to operate properly.
Failure to do so could result in improper ignition
timing retard calibration, erratic behavior or a misfire
in the engine. Mode is only visible as a menu item on
some hardware models.
6 Analog
6425
6427
MSD®
Petronix®
DUI
GM/Delco
Mode is only visible as a menu item on some models.
Note: Davis Technologies is constantly adding
compatibility with different types of ignitions, call if
your ignition is not listed.
All trademarks used herein are the property of their respective owners.
MSD®, HVC™ and Pro Mag® are registered trademarks of
Autotronic Controls Corporation.
FAST™ is a registered trademark of Fuel Air Spark Technology.
Crane® is a registered trademark of Crane Cams®
15
CT Series Traction Control
MSD® Distributor
6AL, 6ALN, 6T, 6TN, HVC™ Crane®, FAST™
Digital 6AL
6CT
(Set Points Output to "None")
HEI 4 Pin Module
88362
D2000
DynaMod
19180771 / D1906
(Set Points Output to "None")
www.moretraction.com
See the table below.
Advertisement
Table of Contents
