Table of Contents
Advertisement
Troubleshooting
•
When your sunbed or part of it (top, bed or facial) does not function, please check
- the fuses/differential switch of your main supply;
- the connection to the main supply and fuse (Fig. 6);
- the (possible) plug connection between the different parts (for example the bed
and top) (Fig. 2, 3 and 4);
- the thermal switches (temperature safety) or the broken-glass sensors for the facials
which are all checked by the IQ Touch Control and become visible on the display in
case failures occur;
•
If one of the lamps does not function anymore, change it with the lamp next to it. In case two
lamps next to each other do not function, the possibility exists that there is a defect in the
starter;
If your facial tanner is out of function, please check the facial switch on the IQ Touch Control first.
•
Hereafter check the switch of the facials on the bed;
•
If the top does not stay in the required positions or it moves up and down by itself, the spring
coils need to be adjusted in the compartments R1 and R2 (Fig. B);
•
Switch off the power supply in case of:
- working inside the sunbed;
- fans are out of order;
- any doubt of the nature of the failure;
•
Please contact your technical service in case the problem cannot be solved with the above
mentioned possibilities;
Maintenance
After 50 hours or at least after one month and then every 500 hours or 6 months:
• Visual inspection of all parts inside the sunbed;
• Remove dust and fluffs inside;
• Check the working of the whole machine;
• Control screws and nuts (if loose tighten);
• Clean the filters of the facials;
Always:
• Pay attention to strange noises in the sunbed;
• Clean the acrylics after every tanning session;
• Consult an authorised service agent in the event your Ultrasun machine has a failure;
16
Advertisement
Table of Contents
