Table of Contents
Advertisement
Changing Lamps And Facial Bulbs
When the effective life of your lamps and facial bulbs is over, or when there is an obvious decrease in
the tanning results, it is necessary to change the lamps and facial bulbs.
ATTENTION: When changing lamps, first remove the power supply, then remove
the acrylic.
The top:
Remove the acrylic by taking out the synthetic strip from the front side. Lower the front side of the
acrylic, preferably with two people, and then lift the back out of the profile of the top. You can now
clean the acrylic and change the lamps. Turn the lamps by turning them in the lamp holder: let them
"click" before you remove them. When changing lamps, also remove the dust from the machine
(particularly around the fans) and clean the acrylics from the inside. Read the chapter about the
(dis)assembly of the Q10 for more details.
The bed:
Lift up the strip from the acrylic on the front side and carefully loosen it over the full length. Once the
strip is removed, the acrylic can simply be lifted and removed, preferably by two people. Turn the
lamps by turning them 90 degrees in the lamp holders: let them "click" before you remove them.
When changing the lamps, also remove the dust from the machine (particularly around the fans) and
clean the acrylics from the inside. Read the chapter about the (dis)assembly of the Q10 for more
details.
The facials:
When changing bulbs, the right side of the top on the outside must be disassembled. By removing
the synthetic strip on the front and backside and the screws on the backside, the cover can be
removed from the frame. The reflector with the facial bulb inside can be completely removed by
turning the two screws (on both sides) out of the reflector.
At the same time the two wires of the facial bulb must be disconnected. The facial bulb can be
removed out of the pinch-spring and replaced by a new one. Do not touch the glass of the facial
bulb with your fingers. Remove the dust and clean the white and blue filter with a glass cleaning
fluid.
ATTENTION: Make sure that the new lamps and facial bulbs are of the same
type as the previous ones.
In order to keep your Ultrasun Q10 machine in compliance with the standard, you have to make sure
to change lamps, components and accessories with original lamps, components and accessories only.
Otherwise guarantee will be taken off as well as any responsibility and any liability.
Many parts can be recycled, so keep them separate and do not dispose of them.
15
Advertisement
Table of Contents
