Safe Operation; Safe Maintenance - ABB XAC25580 Operation Manual

Operation Manual / A200-L
2 Safety / 2.13 Safe operation
2.13

Safe operation

Mechanical hazards during operation
During standard operation, no mechanical hazards are caused by the turbocharger itself if it
has been properly installed.
Safety during commissioning and operation
Visually inspect your working environment before starting work.
u
Remove any obstacles and objects littering the workplace.
u
Check all pipes to and from the turbocharger for damage and leaks before commission-
u
ing.
Check turbocharger for recognisable damage or defects every 12 hours of operation or at
u
least once a day.
Report any damage and any alterations of operational characteristics to the responsible
u
department immediately.
In case of damage, take the turbocharger out of operation immediately and safeguard
u
against accidental/unauthorised use.
When switching on operating energy supplies (hydraulics, pneumatics, electricity), pay at-
u
tention to the risks that may occur as a consequence of this energy input.
2.14

Safe maintenance

Occupational safety
WARNING
Injuries to persons
Severe injuries to personnel or fatal accidents can be caused by mechanical
influences as a consequence of hazardous and inadequate operational pro-
cedures or non-compliance with safety and health standards.
When working on the turbocharger always wear safety footwear and pro-
u
tective clothing to protect against mechanical hazards.
Keep personal protective equipment in perfect condition.
u
Obey mandatory signs.
u
Observe the general rules for occupational safety and prevention of acci-
u
dents.
Only perform operations that are described in this chapter.
u
Only perform operations for which you have received instruction or train-
u
ing.
Wear safety footwear to protect against mechanical hazard and risk of fall-
ing.
Wear protective clothing.
© Copyright 2021 ABB. All rights reserved. HZTL4036_EN Rev.T December 2021