Pioneer GEX-M7347XMZH/XN/UC Service Manual page 58

5
4.9 TERR-BER-INFO
Display format: [T_X. XXEY].
X: Bitabi signal decryption error rate (effective three digits).
Y: Truncated binary exponential (with negative sign abbreviated) of the error rate.
_: Spacing character.
The information will become effective following the initialization of CDEC. The updating interval is 432 ms. If the
wave's modulated signal cannot be received (meaning such a signal cannot be locked on), a hyphen ("-") will be
displayed.
Display example: If the error rate is 0%, the display will show [T_0.00E0].
4.10 MICRO Status 1
Display format: [M1_XX_YY].
X: System operation mode (two effective digits of hexadecimal value).
Y: XM operation mode 1 (two effective digits of hexadecimal value).
_: Spacing character.
System operation mode table
Mode number Mode name
00 STANDBY
01 PWRON
02 1STKEY
05 ENABLECHK
10 OFF
11 ANT_OFF
21 ANT_ON
22 ANT_FLASH
2F ON
81 MODSET
82 MODESET_FREQ
83 MODSET_LEV
84 MODOFFENT
85 MODHOLD
XM operation mode 1 table
Mode number Mode name
HALT
00
ON
01
CHRD
02
CHWD
03
CHUP
04
CHDN
05
PROGUP
06
PROGDN
07
PROG10UP
08
PROG10DN
09
CATUP
0A
CATDN
0B
CATSUP
0C
CATSDN
0D
TRIGON
0E
RX
10
CHUP_WAIT
12
CHDN_WAIT
13
CHUP_REL
14
5
6
Description
Standby mode.
System's powering on process.
Waiting for the 1st key signal from the grille (for FM modulator types only).
Verifying connection (for IP-BUS types only).
XM OFF with ACC ON.
Forcing OFF due to a short-circuited antenna.
Turning ON with a short-circuited antenna.
Displaying the blinking warning indicator for the short-circuited antenna.
Turning XM ON.
Modulator setting mode (for FM modulator types only).
Setting the frequency in the modulator setting mode.
Setting the modulation level in the modulator setting mode.
Waiting for a mode entry in the modulator setting mode.
Waiting for a key entry in the modulator setting mode.
Description
Completed the operation to turn XM OFF.
Turning XM to ON.
Recalling the pre-set channel.
Storing the pre-set channel.
Dialing up the pre-set channel.
Dialing down the pre-set channel.
Dialing the channel up.
Dialing the channel down.
Dialing the channel up quickly (rough dialing).
Dialing the channel down quickly (rough dialing).
Searching category upwards.
Searching category downwards.
Searching inside a category upwards.
Searching inside a category downwards.
No longer receiving the SID signal .
Receiving.
Waiting for the pre-set channel dial up key to be released.
Waiting for the pre-set channel dial down key to be released.
Releasing the pre-set channel dial up key .
GEX-M7027XMZH/XN/UC
6
7
7
8
A
B
C
D
E
F
47
8