Rear-Panel Connections - Harman Kardon HK3375 Owner's Manual

REAR-PANEL CONNECTIONS

¡
AM
LOOP
™
FM
75
£
GND
PHONO CD AUX
IN
¢
∞
OUT
IN IN
§ •
¶
¡ AM Antenna
™ FM Antenna
£ Phono Ground
¢ Remote IR In
∞ Remote IR Out
§ Phono Inputs
¶ CD Inputs
• Aux Inputs
¡ AM Antenna: Connect the AM loop antenna sup-
plied with the receiver to these terminals. If an external
AM antenna is used, make connections to the AM and
GND terminals in accordance with the instructions sup-
plied with the antenna.
™ FM Antenna: Connect an indoor or external FM
antenna to this terminal.
£ Phono Ground: Connect the ground wire from a
turntable to this terminal to reduce system hum.
¢ Remote IR In: If the HK 3375's front-panel
IR sensor is blocked due to cabinet doors or other
obstructions, an external IR sensor may be used.
Connect the output of the sensor to this jack.
8 REAR-PANEL CONNECTIONS
TAPE MON. TAPE 2 MAIN IN PRE OUT SUB OUT
IN PLAY REC. OUT PLAY REC. OUT MONO
‚ ¤ › fl
ª ⁄
‹ fi
ª Tape Monitor Play/In
‚ Tape Monitor Record/Out
⁄ Tape 2 Play/In
¤ Tape 2 Record/Out
‹ Main In
› Pre-Out/Main-In Jumper Pins
fi Preamp Out
fl Subwoofer Out
∞ Remote IR Out: This connection permits the IR
sensor in the receiver to serve other remote-controlled
devices. Connect this jack to the "IR In" jack on
Harman Kardon (or other compatible) equipment.
§ Phono Inputs: Connect the outputs of your
turntable or tonearm to these jacks. Only Moving
Magnet (MM)-type cartridges may be used.
¶ CD Inputs: Connect these jacks to the output of a
compact disc player or CD changer.
• Aux Inputs: Connect these jacks to the line-
level output of any audio device such as a TV,
cable converter or portable audio player.
ª Tape Monitor Play/In: Connect these jacks to
the Play/Out jacks of an audio recorder.
S P E A K E R 1 ( 8 O h m s )
(120V, 60Hz)
RIGHT LEFT
L
R
S P E A K E R 2 ( 8 O h m s )
°
‡
·
‡ Speaker 1 Terminals
° Speaker 2 Terminals
· Accessory Outlets
a Power Cable
‚ Tape Monitor Record/Out: Connect these jacks
to the Rec/In jacks of an audio recorder.
NOTE: When these jacks are connected to a three-
head recorder or another device with off-head play-
back, it will be possible to monitor the source being
recorded.
⁄ Tape 2 Play/In: Connect these jacks to the
Play/Out jacks of a second audio recorder.
¤ Tape 2 Record/Out: Connect these jacks to the
Rec/In jacks of a second audio recorder.
‹ Main In: These jacks are the input to the HK 3375's
power amplifier. Unless an external power amplifier is used,
the Jumper Pins › should remain connected to the
Preamp Out Jacks fi.
AC 120V 60HZ
400W
a