Front Panel Controls - Harman Kardon HK3370 Owner's Manual

Front Panel Controls

Main Power Switch
System Power Control
Power Indicator
Headphone Jack
Mute
Speaker 1 Selector
Speaker 2 Selector
Phone Input Selector
T-Mon Input Selector
Tuning Button
Main Power Switch: Press this button to
apply power to the HK 3370. When the switch is
pressed in the unit is placed in a Standby mode,
as indicated by the amber LED
the System Power Control . This button
MUST be pressed in to operate the unit. To turn
the unit off completely and prevent the use of
the remote control, this switch should be
pressed until it pops out from the front panel so
that the word "OFF" may be read at the top of
the switch.
NOTE: In normal operation this switch is left in
the "ON" position.
4 FRONT PANEL CONTROLS
27 26
MUTE T-MON RDS
Tape Input Selector
Preset Scan
CD Input Selector
Aux Input Selector
Preset Selector
Dimmer
FM/AM Selector
FM Mode Selector
Sleep Button
Bass Control
System Power Control: When the Main
Power Switch
turn on the HK 3370; press it again to turn the
surrounding unit off (to Standby). Note that the Power Indi-
cator surrounding the switch
when the unit is on.
Power Indicator: This LED will illuminate in
amber when the unit is in the Standby mode to
signal that the unit is ready to be turned on.
When the unit is in operation, the indicator will
turn green. A red indicator means that the unit is
in the Protect mode, and should be turned off
and then checked for a possible speaker wire
short circuit.
25
PTY CT RT TA AUTO TUNED ST MEMORY PRESET
SLEEP
is "ON," press this button to
will turn green
24
21
20
Treble Control
Balance Control
Volume Control
Volume/Mute Indicator
Information Display
Speaker Selection Indicators
Remote Sensor Window
Headphone Jack: This jack may be used to
listen to the HK 3370's output through a pair of
headphones. Be certain that the headphones
have a standard 6,3 mm stereo phone plug.
Mute: Press this button to momentarily
silence the speaker and preamp output of the
HK 3370.
Speakers 1 Selector: Press this button to
turn the speakers connected to the Speaker 1
output terminals on or off.
Speakers 2 Selector: Press this button to
turn the speakers connected to the Speaker 2
output terminals on or off.
23
22