Remote Control Functions - Harman Kardon AVR 85 Owner's Manual

b. When CD is selected and the unit
is a CD changer, these buttons
will change to the next disc
previous disc .
Â
c. When Tape 1 or Tape 2 is the
input source, and the tape
machine is a compatible Harman
Kardon dual cassette deck, these
buttons will switch between the
"A" and "B" sides.
u Channel/Skip: These buttons
have multiple functions, which
vary according to the input device
selected and the codes pro-
grammed from another remote.
a. When TV, Vid 1 or Vid 2 are
selected, they may function as
the channel up · or channel
down tuning buttons when
‡
programmed with the codes from
another unit's remote.
b. When CD is selected these
buttons act as forward and
reverse "Skip" buttons to move
to the next track or chapter on
the disc.
c. When a compatible Harman
Kardon cassette player has been
selected as Tape 1 or Tape 2,
these buttons move the tape
forward · or backwards
the next selection using the Music
Scan feature.

Remote Control Functions

v Memo: The memo button is used
to enter stations to the tuner's preset
or
∏ memory in either the manual or auto-
matic modes. It is also used in the
process of clearing the memory. This
button also performs the functions
of the " * " symbol on compatible
equipment.
w P-Scan: Press this button to
automatically scan through the sta-
tions preset into the tuner memory.
Press the button again to end the
scan when the tuner stops at the
desired station. This button also per-
forms the functions of the "#" symbol
on compatible equipment.
x Number Keys: These buttons
serve as a ten button numeric key-
pad to enter tuner preset positions.
They are also to be used to select
channel numbers when TV has
been selected on the remote, or to
select track numbers on a CD, DVD
or LD player, depending on how the
remote has been programmed.
The letters below the buttons are
used to enter information for tuner
station names.
NOTE: The 0 button has a dual func-
tion. It also serves as the CLEAR
button for use in programming the
tuner or clearing the system memory.
‡ to
y Surround Mode Selection:
Press one of these buttons to select
a surround mode for the current
listening session.
12
z Sleep: Pressing this button
when the Sleep timer has previously
been activated allows you to view
the time remaining before the timer
function turns the unit off. When the
remote is in the AM/FM mode d,
the Sleep function may also be set
by pressing this button so that the
Sleep indicator E blinks. Press the
Memo and Sleep buttons within five
seconds to set the desired sleep
time in the following order:
10 20 30 60
min min min min
When the desired time is shown in
the display press the Memo button
^v to enter the time. The unit will
go into the Standby mode when the
time entered has elapsed.
` Learn LED: This indicator will
illuminate when a button on the
remote is being programmed with
signals from another remote during
the "learning" mode. The light will go
out when the signal is received and
memorized.
Sending LED: This indicator
should flash any time a button is
pressed to confirm that a command
is being sent to the receiver or
another unit. If the light is dim or
does not illuminate when a button is
pressed the batteries in the remote
should be replaced.
90
OFF
min