Harman Kardon AVR 525 Owner's Manual page 5

Main Power Switch
System Power Control
Power Indicator
Headphone Jack
Tone Mode
Speaker Selector
Surround Mode Group Selector
Surround Mode Selector
Tuning Selector
Button
Tuner Band Selector
Set Button
Main Power Switch: Press this button to apply
power to the AVR 525. When the switch is pressed
in, the unit is placed in a Standby mode, as indicated
by the amber Power Indicator surrounding the
System Power Control . This button MUST be
pressed in to operate the unit. To turn the unit off and
prevent the use of the remote control, this switch
should be pressed until it pops out from the front
panel so that the word "OFF" may be read at the top
of the switch.
NOTE: This switch is normally left in the "ON" position.
System Power Control: When the Main Power
Switch is "ON, " press this button to turn on the
AVR 525; press it again to turn the unit off. Note that
the Power Indicator surrounding the switch will
turn green when the unit is on.
Button
Preset Station Selector
Input Source Selector
Tuner Mode Selector
Optical 3 Digital Input
Input/Output Status Indicator
Coaxial 3 Digital Input/Output
Video 4 Input/Output Jacks
Bass Control
Balance Control
Treble Control
Channel Adjust Selector
Power Indicator: This LED will be lit in amber
when the unit is in the Standby mode to signal that the
unit is ready to be turned on. When the unit is in oper-
ation, the indicator will turn green.
Headphone Jack: This jack may be used to listen
to the AVR 525's output through a pair of headphones.
Be certain that the headphones have a standard
stereo phone plug. The main room speakers will
automatically be turned off when the headphone jack
is in use.
Tone Mode: This button controls the tone control
settings, enabling adjustment of the bass and treble
boost/cut or the removal of the tone controls from the
signal path. The first press of the button displays a
TONE IN message in the Main Information
Display . If you wish to set the tone controls to "flat, "
without any treble or bass alteration, press the
26
Delay Adjust Selector
Digital Input Selector
Volume Control
Input Indicators
Main Information Display
Remote Sensor Window
Surround Mode Indicators
Selector Buttons
appears in the Lower Display Line
Speaker Selector: Press this button to begin the
process of configuring the AVR 525 for the type of
speakers it is being used with. For complete informa-
tion on configuring the speaker settings using the
1
/ " front-panel controls see page 23.
4
Surround Mode Group Selector: Press this but-
ton to select the top-level group of surround modes.
Each press of the button will select a major mode
grouping in the following order:
Dolby Modes _ DTS Digital Modes _ VMAx Modes
Dolby Modes DTS Digital Modes
_ DSP Modes _ Stereo Modes _ Logic 7 Modes
DSP Modes Stereo Modes
B
Once the button is pressed so that the name of the
desired surround mode group appears in the on-screen
or
display and in the Lower Display Line
25
so that TONE OUT
.
VMAx Modes
Logic 7 Modes
, press the