Hyundai stargazer 2022 Owner's Manual page 356

CAUTION
Securely install the sealant filling hose
to the valve. If not, sealant may flow
backward, possibly clogging the filling
hose.
5. Plug the compressor power cord (4)
into the vehicle power outlet.
NOTICE
Only use the front passenger side power
outlet when connecting the power cord.
6. Switch on the ignition switch.
7. Switch on the compressor and let it run
for approximately 5~7 minutes to fill
the sealant up to proper pressure. (re-
fer to the Tire and Wheels, chapter 8).
The inflation pressure of the tire after
filling is unimportant and will be
checked/corrected later.
Be careful not to overinflate the tire
and stay away from the tire when filling
it.
CAUTION
Tire pressure
Do not attempt to drive your vehicle if
the tire pressure is below 200 kPa (29
psi). This could result in an accident due
to sudden tire failure.
8. Switch off the compressor.
9. Detach the hoses from the sealant bot-
tle connector and from the tire valve.
Return the Tire Mobility Kit to its storage
location in the vehicle.
WARNING
Carbon monoxide
Do not leave your vehicle running in a
poorly ventilated area for extended pe-
riods of time. Carbon monoxide poison-
ing and suffocation can occur.
OKS082035L OKS082035L
10. Immediately drive approximately 7~10
km (4~6 miles or, about 10min) to
evenly distribute the sealant in the tire.
Do not exceed a speed of 80 km/h (50
mph). If possible, do not fall below a
speed of 20 km/h (12 mph).
While driving, if you experience any un-
usual vibration, ride disturbance or noise,
reduce your speed and drive with caution
until you can safely pull off of the side of
the road.
Call for road side service or towing.
08
OKS082036L OKS082036L
8-27