Advertisement
know your table top
before plugging in
Make sure your electricity supply is
●
can opener
the same as the one shown on the
underside of your can opener.
Your Kenwood Can Opener can be
used to open a variety of domestic
Important – UK only
can shapes and sizes. In addition the
●
The wires in the cord are coloured
as follows:
CO606 incorporates a bottle opener
and a knife sharpening facility.
Blue = Neutral, Brown = Live.
The appliance must be protected
●
before using your Kenwood
by a 3A approved (BS1362) fuse.
appliance
●
Read these instructions carefully
Note:
and retain for future reference.
For non-rewireable plugs the fuse
●
●
Remove all packaging and any
cover MUST be refitted when
labels.
replacing the fuse. If the fuse cover
is lost then the plug must not be
safety
used until a replacement can be
obtained. The correct fuse cover is
●
Do not immerse appliance, cord or
identified by colour and a
plug in water or other liquid.
replacement may be obtained from
●
Never use a damaged appliance.
your Kenwood Authorised Repairer
Get it checked or repaired: see
(see Service).
'service and customer care'.
If a non-rewireable plug is cut off it
●
●
Unplug the appliance from the
must be DESTROYED
mains supply
IMMEDIATELY. An electric shock
before cleaning
● ●
hazard may arise if an unwanted
immediately after use.
● ●
non-rewireable plug is inadvertently
This appliance is not intended for
●
inserted into a 13A socket outlet.
use by persons (including children)
This appliance conforms to EC
●
with reduced physical, sensory or
directive 2004/108/EC on
mental capabilities, or lack of
Electromagnetic Compatibility and
experience and knowledge, unless
EC regulation no. 1935/2004 of
they have been given supervision or
27/10/2004 on materials intended
instruction concerning use of the
for contact with food.
appliance by a person responsible
for their safety.
key
Children should be supervised to
●
ensure that they do not play with
bottle opener
the appliance.
drive wheel
Only use the appliance for its
●
magnet
intended domestic use. Kenwood
lever
will not accept any liability if the
cutter blade
appliance is subject to improper
guide pin
use, or failure to comply with these
knife sharpener
instructions.
cord stowage
using your table top can
opener
1 Ensure that the lever is in position
with the magnet housing fully
located (Fig. 1 and 2).
2 Plug the appliance into the power
supply.
3 Lift the lever to the open position.
4 Hold the can with the top rim
resting under the metal guide pin
and the can resting on the drive
wheel (Fig. 3).
5 Press the lever lightly down to start
the motor. The self-starting blade
will then pierce the can and
commence cutting.
6 The can will be held fixed in position
with the magnet resting against the
lid. Large or wide cans may require
extra support from the user.
7 Once the can is open, the motor
will automatically stop, retaining the
can and lid safely in place.
8 To remove, lift the lever whilst
holding the can.
9 With the exception of aluminium
cans, the lid will be retained by the
magnet.
10 For tidiness, any unwanted length
of cord can be stowed inside the
appliance.
using the bottle opener
When opening tall bottles, the unit
should be used towards the edge
of a work top.
1 Position the bottle with the cap
under the front rim of the bottle
opener.
2 Push down the bottle to remove the
cap whilst steadying the unit with
one hand.
Fig. 1
Fig. 2
Fig. 3
Advertisement
