Discharging Equipment - BYD ATTO 3 2022 Owner's Manual

3. Stopping charging 3. Stopping charging
• Stopping charging:
• When early stop is set or charging
has been completed, the charger will
automatically stop.
• Double tap the unlock button within
3 seconds or press the door handle
microswitch to stop charging.
• Disconnecting the coupler:
• Press the door handle microswitch
while carrying the smart key and pull
out the charging coupler.
• Place the charging coupler in its
designated position.
• Reinsert the cover and close the port
hatch.
REMINDER
•If the charging port plug is fully open,
do not close the charging port cover
completely.
CAUTION
•If the charging coupler cannot be
removed after unlocking, a few more
unlocking attempts can be tried. If it
still cannot be removed, emergency
unlocking can be tried. Refer to the
charging port emergency unlocking
procedure in the lock control.
•To unlock during DC charging, press
the unlock button twice within 3
seconds for the operation to be
successful.
•For specific charging precautions,
refer to the charging instructions.
WARNING
•
For specific charging safety warnings,
refer to the charging instructions.
88
Smart Charging Function
• When the manager detects that the low
voltage battery capacity is low, it can be
charged by the power battery, so it is
normal that the SOC and driving range
displayed decrease when the vehicle is
powered on after an idle period.
REMINDER
•When the vehicle lies idle for long pe-
riods, it is normal that smart charging
takes place.
•Power for smart charging comes from
the power battery pack, so it is nor-
mal that an SOC decrease is noticed
when the vehicle is powered on.

Discharging Equipment*

• This vehicle features a vehicle to load
(VTOL) function.
REMINDER
•This function is recommended to be
used only when SOC is high.
•This function will be limited when the
vehicle is using external discharge or
when power is low.
•When ignition status is OFF and
VTOL is connected without output
for a long time, the vehicle's static
power consumption increases. It is
recommended that the discharging/
charging connectors are removed
when the device is not in use.