Advertisement
Installation and performance
Install the skimmer in reference to the im-
age. The skimmer floating rate is adjustable.
The skimmer collects leaves fallen onto the
water surface. An inner filter which is
blocked interferes with this function. When
used on a water surface that is quite dirty,
the skimmer should be raised slightly to re-
duce the amount of dirt let in by the skim-
mer.
The skimmer is to be supplied through a re-
sidual current device with a rated residual
operating current not exceeding 30 mA.
Maintenance
To clean the filter pump, remove the back cover and impeller.
Use a small brush or a stream of water to remove any dirt.
Attention:
The pump shaft cannot be removed.
If the pump fails to operate:
•
Check the fuse and try another plug to ensure the skimmer is getting electrical power.
•
NOTE: Always disconnect from current supply before manipulating the skimmer.
•
Check the skimmer outlet and tubing for kinks and obstructions. Algae build up can be flushed
out with a garden hose.
•
Check the inlet to ensure it is not clogged with dirt.
•
Remove the skimmer inside pump inlet to access the impeller area. Turn the rotor to ensure it
is not broken or blocked.
Monthly maintenance will prolong the operation life of the skimmer.
Caution:
Ensure that the electrical cord forms a loop below the electrical outlet to form a "Drip
Loop," which prevents water from running down the cord into the point.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 50117–50119
№
Name
1
Water ring
2
Filter cartoon
3
Skep
4
Auricular angle
5
Main body
6
Water pump
7
Bottom cover
Page 4
08
2022-1
Advertisement
