Page 1
Oasis products must be installed, operated and maintained by trained and competent personnel in accordance with all applicable local codes, rules and regulations in addition to the Oasis Instructions. Oasis Engineering Ltd. will not be held liable in such circumstances where installation, operation and maintenance procedures were performed by incompetent personnel resulting in improper assembly, unsafe operation, equipment damage or personal injury.
Page 2
High pressure gas and gas equipment can cause serious harm to both infrastructure and personnel if safety precautions are not followed. Oasis recommends considering the use of the following PPE when working with high pressure along with any other site specific health and safety requirements:...
Page 3
1 x Vent End Cap 1 x 1/4” Vent Tube 1 x Two Piece Handle Sleeve with O-ring Assembly with Screws and Nuts The Complete Oasis Seal Kit must be used Tools Required For Servicing Sockets Torque Wrench 21mm Spanner...