Ryobi P2170 Operator's Manual page 12

STARTING/STOPPING THE BLOWER (AC)
See Figures 4 - 6.
 Remove battery pack from the blower if installed.
 Slide power selection door over battery port until it clicks
into place.
 Route an extension cord loop through the slot located
above power cord receptacle and wrap through the cord
retainer.
NOTICE:
Always use cord retainer to properly attach extension
cord to the blower. Failure to use cord retainer may result
in damage to the blower and/or extension cord.
 Attach the outlet end of an extension cord to the plug on
the rear of the the blower.
NOTE: Use only approved outdoor extension cords.
 To start the blower, place the power switch in the ON ( l )
position.
 To stop the blower, place the power switch in the OFF
( O ) position.
OPERATION
OPERATING THE BLOWER
See Figure 7.
 To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
 To reduce sound levels, limit the number of pieces of
equipment used at any one time.
 Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water
is available.
 Conserve water by using power blowers instead of hoses
for many lawn and garden applications, including areas such
as gutters, screens, patios, grills, porches, and gardens.
 Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
 After using blowers or other equipment, CLEAN UP!
Dispose of debris properly.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be in the OFF position when not in
use or carrying at your side.
10 — English