Tymate M7-3 User Manual page 3

Thanks for choosing our TPMS product. The sysetm is used to detect the pressure and
temperature in the tire. After the alarming condition is set up by the user, the system will
alarm under the situations of abnormal pressure and temperature and warn the driver of
dangerous driving. The system also enhance the efficiency of fuel, prolong the lifespan of the
tire and make the driving more comfortable.
Be sure to read the user instruction carefully before installation and keep it for future use.
It is highly recommended to read the instructions below before installing the system:
1. The monitor should be installed inside the vehicle where it does not affect normal driving.
2. The monitor should be well fixed to avoid falling off while driving.
3. The tires temperature and pressure will increase while driving. The vehicle should be
stopped for cooling if there is high temperature alarm to avoid braking problem or tire blowout.
4. Driver should stop the vehicle and get off to check the tire if the high pressure or slow
leakage alarm still rings.
5. Be aware of tire blowout if the tire pressure is a high and pay attention to fuel consumption
and wheel balance under the situation of low tire pressure.
6. The system can effectively detect tire pressure and temperature but cannot avoid traffic
accident after tire brow out. It is still necessary to use high quality tire product and correct tire
pressure monitoring.
7.Pay attention to driving safety when you check the data while driving.
8.After the system is installed correctly, the driver does not need to stare at the monitor all the
time or feel distracted while driving.
1. The monitor will be in sleeping mode to save battery lifespan if the motion sensor detects
the vehicle has stopped for ten minutes. It will turn on again when it detects the vehicle is
moving again. If one of the sensor data has not been displayed on the monitor at the
beginning, the data will be displayed later when there is any change of the pressure or
temperature in the tires.
2. The signal transmission from the monitor to sensors is wireless, and the transmission
distance is long enough for normal use in a car. And it is designed with internal anti-
intereference circuit.
3. Due to the air expansion and contraction, the tire pressure and temperature will normally
change all the time while driving
4. There is normal air leakage in the rim of every tire. The tire pressure will be changed after
long-time storage or driving.
5. When encoding the sensor for the first time, please turn on the power of the monitor first,
and then install the sensor on the tire for encoding.
6. Should you have any question or problem while installation, please contact with your
local distributor.