Maintenance - MULTIQUIP GLOBUG GB12BW Operation And Parts Manual

GLOBUG GB12BW/BS/BP LIGHTING SYSTEM — MAINTENANCE
CAUTION - READ SAFETY GUIDELINES
Before performing any maintenance
procedures, be sure to READ the lamp,
balloon, and general safety guidelines in
this manual. Failure to read and
understand these safety guidelines
could cause severe equipment damage and bodily harm.
Replacing the Lamp
1. Allow lamp (Figure 32) 15-20 minutes to cool before chang-
ing.
Figure 32. Hot Lamp Surface
1. If lamp assembly is attached to mast, loosen upper T-
handle bolt lock that secures the lamp to the mast and
remove.
2. Unzip the zipper at the bottom of the balloon. DO NOT
use excessive force when unzipping the balloon.
3. Place lamp/balloon assembly on a suitable work bench
that is free of dirt, and sharp objects that could damage
the balloon.
CAUTION - BALLOON ZIPPER SAFETY
DO NOT use excessive force when zipping or
unzipping the balloon. The possibility exists
of the zipper tearing, which would make the
balloon unusable.
PAGE 24 — GLOBUG LIGHTING SYSTEM — OPERATION AND PARTS MANUAL — REV. #2 (11/03/08)
4. Roll the balloon envelope (Figure 33) upwards to expose
the lamp.
ZIPPER
Figure 33. Rolling Up Balloon Enevlope
5. Release the lamp guard locking tabs (Figure 34).
LAMP
GUARD
Figure 34. Releasing Lamp Guard Locking Tabs
6. Remove lamp guard (Figure 35).
LAMP
GUARD
Figure 35. Lamp Guard Removal
BALLOON
ENVELOPE
LOCK
TAB
LOCK
TAB